A digital-watch style font that expands to fill the available space.
Please follow the instructions here to unlock this product.
In free mode, this is a very big digital-watch style field that expands to fill the maximum available space on your device, and that you can configure to display any one of thirty different metrics! (See below.)
If you also purchase a code from https://pdf.gdcsoft.com/garmin/startPurchase/MaxHuge then you will also get the ability to set low and high targets, colours for each range, and buzz or tone alerts when entering or leaving your target zone.
A single code will unlock all clones of this field.
SUPPORTED DISPLAY VALUES
- Elapsed time M:S
- Elapsed time H:M
- Elapsed time H:M:S
- Power (watts)
- Average power (watts)
- Max power (watts)
- Current cadence
- Average cadence
- Max cadence
- Current heart rate
- Average heart rate
- Max heart rate
- Elapsed distance (Km)
- Current speed (KPH)
- Average speed (KPH)
- Max speed (KPH)
- Pace (min/100m)
- Pace (min/km)
- Pace (min/5km)
- Elapsed distance (Miles)
- Current speed (MPH)
- Average speed (MPH)
- Max speed (MPH)
- Pace (min/100yd)
- Pace (min/mile)
- Pace (min/5mile)
- Altitude (m)
- Ascent (m)
- Descent (m)
- Calories per minute
- Metabolic units
- Metabolic units per minute
You can specify either a single target or two targets. For two targets, enter both targets separated by a comma. EG: To set a heart rate of 150 to 180, you would use 150,180.
SETTING HEART RANGE
Heart ranges use simple numbers for each value, so 120,140 would set the range 120 to 140 bpm. However, you can also use zone values with z1 up to z5 to set low and high targets to the minimum and maximum of heart zones 1 to 5.
SETTING PACE OR TIME
Times and paces are expressed in mm:ss or hh:mm:ss with ":" as the separator. Valid units are;
- "/100m" for time to complete 100m
- "/km" for time to complete one km
- "/5km" for time to complete five kms
- "/10km" for time to complete ten kms
- "/100y" for time to complete 100yards.
- "/M" for time to complete one mile
- "/5M" for time to complete five miles
- "/10M" for time to complete ten miles
- "/half-marathon" for time to complete half-marathon
- "/marathon" for time to complete marathon
No units is interpreted as a time, so you could use “01:00:00” on an elapsed time field to buzz after one hour.
SETTING OTHER VALUES
Valid units are:
- "mps" for metres per second
- "kph" for kilometres per hour
- "mph" for miles per hour
- "mets" for metabolic units
- "cals" for calories
If you find you love it, please leave a favourable review here .
If you encounter any problems or have any questions, please email me details at firstname.lastname@example.org.